Le Creuset Traditional Kettle 2.1L Stainless Steel

Before first use

Wash your Le Creuset product in warm, soapy water; then rinse and dry thoroughly. Before you first use your kettle, remove the lid, fill the kettle with clean water, boil it, then discard the water. Don’t fill above the marked line.

Use

• For induction hob cooking, avoid using the ‘boost’ function as it should only be used for rapid heating large volumes of water.
• Use the product on the most appropriately sized hob ring to avoid damage or overheating. This is especially important on induction hobs: if you use the wrong-sized ring, there’s a risk the hob won’t ‘recognise’ the product.
• On induction hobs/stove tops, do not rely on the automatic switch-off function. In case of malfunction, all the water in the kettle may evaporate, causing damage by overheating.
• Lift the kettle on and off, or across the surface instead of sliding to avoid damaging the base of the kettle or the surface
• When hot, rest it on a heat-resistant surface.
• For those kettles with a foldable handle, do ensure that the handle is firmly in the upright position before placing the kettle on the heat source to avoid possible handle overheating.
• Close the lid tightly to keep the handle safe from steam.
• Always make sure the spout and lid indentations are pointing away from you and others.
• Do not allow the kettle to boil dry, as this will quickly lead to overheating.
• Remember to turn off the heating source when the water starts boiling, and remove the kettle from the heating source.
• Boiled your water? Wait 10-15 seconds before removing the kettle from the heat, then go ahead and pour. Never tip the kettle upside down. Make sure the lid knob is pressed firmly down.
• Allow your kettle to cool thoroughly before refilling it with cold water.

Cleaning

• Clean your kettle after each use – hand wash it with a neutral detergent. Never use abrasive scrubbers or detergents as they could damage the surface. Done? Dry your kettle thoroughly to prevent mineral deposits.
• Don’t leave water sitting in your kettle when it’s not in use.
• To remove mineral deposits fill the kettle up to the maximum mark level with a mixture of 50% water and 50% white vinegar and allow to simmer for 20 minutes. If deposit persists use a gentle descaler.
• Dry well after washing and store in a dry place.